in the CLI what is the sfp port ?
in the cli i can access the info of the rj45 ports by using show interface switchport 1 to show interface switchport 5
but how do i show the info in the cli about the sfp port ?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
This model does not support querying the SFP WAN port via CLI.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Thank you for your post. Could you please let us know the hardware and firmware version of your ER7206? Is any device connected to the SFP port, and is it currently configured as a WAN or LAN port? Additionally, which method are you using to access the CLI—Telnet, SSH, or the Terminal tool in our Omada Controller?
- Copy Link
- Report Inappropriate Content
the sfp port on this model can only be an wan port
and i tried it with it connected or not
bnoth terminal tool and ssh
- Copy Link
- Report Inappropriate Content
here is what i see :
(config)#show interface status
-------------------------------------------------------------------------------------------------------
Port Status Speed Duplex FlowCtrl Mtu Active-Medium
---- ---- ---- ---- ---- ---- ----
port1 LinkDown N/A N/A N/A 1518 copper
port2 LinkDown N/A N/A N/A 1518 copper
port3 LinkUp 1000M Full Enable 1518 copper
port4 LinkDown N/A N/A N/A 1518 copper
port5 LinkUp 1000M Full Enable 1518 copper
-------------------------------------------------------------------------------------------------------
no SFP seen
- Copy Link
- Report Inappropriate Content
This model does not support querying the SFP WAN port via CLI.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 165
Replies: 6
Voters 0
No one has voted for it yet.