Hello, I have a TP-Link EAP650 access point that I would like to connect to my MikroTik router (RB5009UPr+S+IN) on port ether2. I bought the access point knowing that I can set up VLAN's on it and set up network segmentation trunked from the router to multiple WLAN's on the AP. This is my setup:

• On my router, ether1 is a WAN port. A bridge network exists (192.168.1.0/24).
• ether2 is connected to the EAP650.
• Three VLAN's have been created on the router, vlan-id 10, 15, 20. Subsequently, IP address networks created for each:
  • Gateways 10.1, 15.1, 20.1.
  • DNS server 1.1 (matching the bridge network).
• Each VLAN (10, 15, 20) acts as an interface, and is tagged to bridge and ether2. Ether2 acts as a trunk port.

I have set up other ports (access not trunk) on the router that are on VLAN30, and VLAN30 is only tagged to the bridge with these ports untagged (for instance, ether3).

Whenever I connect the access point to ether3, the AP gets an IP address. But on ether2, it disconnects.

Anyone who may help to fix the trunking issue? Much appreciated.