Business CommunityControllersWhitelisting
Controllers

Whitelisting

Whitelisting

Whitelisting
Whitelisting
2 weeks ago
Model: OC200  
Hardware Version: V1
Firmware Version: latest

I am not sure where to put this question as it is across all of the access devices.

 

I have three vlans one of which I need to tigthen up a little and was thinking of adding a whitelist with MAC address of the devices, only needs to be simple but enoguh for it to need an admin to approve so questions can be asked about the device being added.

 

I have had a look through the controller where there are quite a few entires to security and network access but I can't see anything. The whitelists I have found look to be global and not able to be tied to a vlan. I don't want the guest network having an admin overhead on.

 

If anyone has any suggestions as to how to achieve this simply would be really grateful, I need to stop the free for all in my office.

 

Many thanks, Geoff

0
0
#1
3 Reply
Re:Whitelisting
2 weeks ago

Hi  @biomed32uk 

 

Thanks for posting here.

 

For Wired networks, you can configure 802.1X authentication. Below is a configuration guide:
How to configure 802.1X VLAN Assignment on Omada Controller

 

For wireless networks, MAC filtering is for your case. Below is a guide:

How to configure MAC filtering for EAP in Controller mode

 

Note: The screenshots in the links were from an older controller, while the configure steps are basically the same.

Wish you a happy life and smooth network usage!  >Get the Latest Omada SDN Controller Releases Here< >Get the Latest Firmware Releases for Omada Routers Here< >Experience the Latest Omada EAP Firmware<
0
0
#2
Re:Whitelisting
2 weeks ago

  @Vincent-TP 

 

OK, so I am fighting with this and setting up .X on the wired. 

 

Read the guide from the link attached, plus the Omada manual a few times.

 

I have a test site that uses a SW controller so have a RADIUS server built in. Make the setup, creat the server, create the user, assign .X to a port on a switch and it still behaves as if no authenticaton is present.

 

Does anyone have this working anywhere or has ever got it to work ?. 

 

Geoff

0
0
#3
Re:Whitelisting
2 weeks ago

Hi  @biomed32uk 

 

With the correct configuration, this will work. We have numerous users using this feature.

To find out the reason, you may share screenshots of your specific config, and we will help you determine the cause.

Or you can contact the support team, send your config to them, and they will help you step by step.

biomed32uk wrote

  @Vincent-TP 

 

OK, so I am fighting with this and setting up .X on the wired. 

 

Read the guide from the link attached, plus the Omada manual a few times.

 

I have a test site that uses a SW controller so have a RADIUS server built in. Make the setup, creat the server, create the user, assign .X to a port on a switch and it still behaves as if no authenticaton is present.

 

Does anyone have this working anywhere or has ever got it to work ?. 

 

Geoff

 

Wish you a happy life and smooth network usage!  >Get the Latest Omada SDN Controller Releases Here< >Get the Latest Firmware Releases for Omada Routers Here< >Experience the Latest Omada EAP Firmware<
0
0
#4

Information

Helpful: 0

Views: 151

Replies: 3

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.