TL-SG3424P DHCP Question

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
12

TL-SG3424P DHCP Question

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
12 Reply
Re:TL-SG3424P DHCP Question
2017-12-22 19:48:23
Oke here i am again... I was looking further yesterday and today and also tested today.
When i connect our server to vlan 10 and a pc to vlan 20 i still can go to the documents on the server (it should not be possible to cces the files from the) what am i doing wrong?
Also thinking about to put the switch to factory defaults and start over...
Th meaning would be to connect the inrnet connection from the router to port 1.
Then create vlan 10 (shop) on ports 2 - 10 and create a vlan 20 (technical department) on pôrts 11-20.
The pc's we connect to vlan 20 should not connect with the serve and pc's that will be connect on vlan 10. But they als need to go to internet...
I hope someone can help me clear it a little bit out.

Alleady a big thx for all th support here ;-)
  0  
  0  
#12
Options
Re:TL-SG3424P DHCP Question
2017-12-22 20:04:15
If you assign all ports to the same subnet, the router will forward packets of all devices in this subnet regardless of the VLANs used for transport.

On the router, you need to a) assign an own interface for each separate subnet which should handle the devices in a VLAN and b) use firewalling (or ACLs) to prevent inter-VLAN routing.
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#13
Options
Related Articles