Tl-sg3424p
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Tl-sg3424p
Model :
Hardware Version :
Firmware Version :
ISP :
I have a TL-SG3424P and I need to configure vlans on it. I have 4 set up, but I cannot get 3 of them to access the 4th. not sure what I am doing wrong.
I have Port 1-2 on vlan 110
I have Port 3-4 on vlan 117
I have Ports 5-22 on vlan 100
I have Ports 23-24 on vlan 1 - WAN
if I set all ports to PVID 1 then they can all communicate with the WAN. once I change the PVID on any of the ports they quit communicating with the WAN vlan. I need all 3 vlans to communicate with the WAN vlan, but not to communicate with each other. I am new to switch programming and I cant get the interconnects to work for some reason. what am I missing or do I have programmed wrong?
Thanks,
Hardware Version :
Firmware Version :
ISP :
I have a TL-SG3424P and I need to configure vlans on it. I have 4 set up, but I cannot get 3 of them to access the 4th. not sure what I am doing wrong.
I have Port 1-2 on vlan 110
I have Port 3-4 on vlan 117
I have Ports 5-22 on vlan 100
I have Ports 23-24 on vlan 1 - WAN
if I set all ports to PVID 1 then they can all communicate with the WAN. once I change the PVID on any of the ports they quit communicating with the WAN vlan. I need all 3 vlans to communicate with the WAN vlan, but not to communicate with each other. I am new to switch programming and I cant get the interconnects to work for some reason. what am I missing or do I have programmed wrong?
Thanks,