TL-SG1016PE powering CPE210
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SG1016PE powering CPE210
Model :
Hardware Version :
Firmware Version :
ISP :
Hi,
I try to power a TL-CPE210 Accesspoint with one of the PoE ports of TL-SG1016PE, but this does not work.
The CPE210 works with the power injector T240100-2-PoE. The CPE210 is my only PoE device, so I cannot test with others.
It this a general incompatibility, or just a configuration thing? The SG1016PE is in factory default (just changed the IP).
If this is a incompatibility, which switch I have to use to power CPE210?
The fan is running all the time. Is this normal, or is there a possibility to run the fan only if necessary?
Thanks
Martin
Hardware Version :
Firmware Version :
ISP :
Hi,
I try to power a TL-CPE210 Accesspoint with one of the PoE ports of TL-SG1016PE, but this does not work.
The CPE210 works with the power injector T240100-2-PoE. The CPE210 is my only PoE device, so I cannot test with others.
It this a general incompatibility, or just a configuration thing? The SG1016PE is in factory default (just changed the IP).
If this is a incompatibility, which switch I have to use to power CPE210?
The fan is running all the time. Is this normal, or is there a possibility to run the fan only if necessary?
Thanks
Martin
