T2600G-28 TS - Failed to get time from NTP Server
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
T2600G-28 TS - Failed to get time from NTP Server
Model :
Hardware Version :
Firmware Version :
ISP :
Issues: Failed to get time from NTP Sever
TP-LINK Model: T2600G-52TS
Firmware Version: 2.0.0 Build 20170928 Rel.34921(s)
Bootloader: Version: TP-LINK BOOTUTIL(v1.0.0)
Primary NTP Server: 133.100.9.2
Secondary NTP Server: 139.78.100.163
1. I change the IP address of the T2600G-52S to 10.0.0.21
2. I changed the Subnet Mask to 255.255.255.0
3. I changed the Gateway to 10.0.0.1 which is my Comcast Router
When I attempt to get a update from the NTP Server I get the failed to get time from NTP Server error message.
The exact same setting on a TP-LINK Model TG2500G-10TS works perfectly.
a. I configured the Switch IP Address and Default Gateway based on the instructions in the T2600G Series Switches Configuration Guide (September 2017)
b. The IPv4 Routing Information Summary matches the example shown in the manual with the exception that I am using a 10.0.0.x network.
What am I doing wrong?
Hardware Version :
Firmware Version :
ISP :
Issues: Failed to get time from NTP Sever
TP-LINK Model: T2600G-52TS
Firmware Version: 2.0.0 Build 20170928 Rel.34921(s)
Bootloader: Version: TP-LINK BOOTUTIL(v1.0.0)
Primary NTP Server: 133.100.9.2
Secondary NTP Server: 139.78.100.163
1. I change the IP address of the T2600G-52S to 10.0.0.21
2. I changed the Subnet Mask to 255.255.255.0
3. I changed the Gateway to 10.0.0.1 which is my Comcast Router
When I attempt to get a update from the NTP Server I get the failed to get time from NTP Server error message.
The exact same setting on a TP-LINK Model TG2500G-10TS works perfectly.
a. I configured the Switch IP Address and Default Gateway based on the instructions in the T2600G Series Switches Configuration Guide (September 2017)
b. The IPv4 Routing Information Summary matches the example shown in the manual with the exception that I am using a 10.0.0.x network.
What am I doing wrong?
1 Accepted Solution
Re:T2600G-28 TS - Failed to get time from NTP Server
1. This is the interface configuration.
IPv4 Routing Table Configuration. 10.0.0.1 is the Comcast modem / router.
The IPv6 Routing Table is disabled. The message that confirms this was not able to be captured.
This is the NTP Server configuration. The error message that indicates that the time could not be retrieved form the NTP server was not able to be captured.
IPv4 Routing Table Configuration. 10.0.0.1 is the Comcast modem / router.
The IPv6 Routing Table is disabled. The message that confirms this was not able to be captured.
This is the NTP Server configuration. The error message that indicates that the time could not be retrieved form the NTP server was not able to be captured.