2 AP330 Client fix to one Ap

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2 AP330 Client fix to one Ap

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
2 AP330 Client fix to one Ap
2 AP330 Client fix to one Ap
2017-12-15 03:17:09
Model :

Hardware Version :

Firmware Version :

ISP :

I have different AP 330 with same SSID , Load Balancing etc. is it possible to bind a Client via MAC to a specific AP ?
Because some Clients only connect to an AP that is not in the best Range
Kind regards Marcus
  0      
  0      
#1
Options
1 Reply
Re:2 AP330 Client fix to one Ap
2017-12-29 17:53:32
Hey bro!

If you are using two EAP330s in standalone mode, you can set Mac filter for each EAP330, it will bind your clients to specific AP.
You can refer to page 37 of the UG of EAP products : http://static.tp-link.com/2017/201712/20171201/1910012254_EAP_UG.pdf

If you are using EAP Controller to manage EAP330, you can set a RSSI Threshold, may be -70dBm is better. Then the AP will kick
clients off whose signal strength is lower than -70dBm, and force clients to connect to another EAP which signal strength is better.
You can refer to page 85 of the UG of EAP Controller : http://static.tp-link.com/2017/201711/20171117/1910012227_EAP Controller 2.5_UG.pdf

Hope it may help you.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 585

Replies: 1

Related Articles