Networking questions with 2 ISP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Networking questions with 2 ISP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Networking questions with 2 ISP
Networking questions with 2 ISP
2017-12-28 10:23:32
Model :

Hardware Version :

Firmware Version :

ISP :

Hello.

I am new to building out door network with 2 ISP. I have two TP CPE210s, TD-9970 router/modem, Bell T1000 router/modem, and Cisco RV320. Basically I want to build a network that outdoor users can access the internet using WIFI:
CPE210s will be used as outdoor access points
[*]TD9970 will be logged into an ISP using PPPoE connection to provide internet connection
[*]Bell T1000 will be also providing internet connection using PPPoE
[*]RV320 - Dual WAN router will be used to load balance the internet connection




1. Can you please take a look at the attached the network diagram and confirm the design works?
2. Where do I enter PPPoE user ID and Password? In TD9970 / T1000? What about at RV320? Or do i just put Assign IP automatically in RV320 and CPE210?

Thank you very much!
  0      
  0      
#1
Options
3 Reply
Re:Networking questions with 2 ISP
2017-12-28 14:33:47
Hi,

CPE210 is only good for a long distance of point to point connection but not good for outdoor wifi coverage for wifi clients because CPE210 is equipped with directional antenna.
I would recommend outdoor AP with onmi-antennas such asTP-Link EAP110-Outdoor(2.4G only) or EAP225-Outdoor (Dual band).

For the WAN configuration, there are two options,
Solution A:

1. Let the two modems work in PPPoE mode and input PPPoE username and password on the two modem/routers. Two routers can provide Wi-Fi coverage for the inside of house.
2. Establish two stable links in RV320. Go to System Management- dual WAN and edit WAN 1 and WAN 2. Configure Dynamic IP in RV320.
3. Add an EAP110/225-Outdoor for outdoor use.

In this situation, clients connected to 9970, clients connected to T1000 and the clients connected to EAP110-Outdoor are in the different subnets which cannot communicate directly.

Solution B:

1. Let the two modems work in bridge mode and input PPPoE username and password on the RV320. Two routers will not provide Wi-Fi coverage for the inside of house.
2. Establish two stable PPPoE links in RV320. Go to System Management- dual WAN and edit WAN 1 and WAN 2. Configure PPPoE in RV320.
3. Add an EAP110/225-Outdoor for outdoor use. Add an EAP225 for indoor use.

In this situation, clients connected to EAP110-Outdoor and the clients connected to EAP225 are in the same subnets which can communicate directly.
File:
RV320 Dual-WAN.pngDownload
Bridge on 9970.pngDownload
Soultion B.JPGDownload
Solution A.JPGDownload
  0  
  0  
#2
Options
Re:Networking questions with 2 ISP
2017-12-30 05:44:42
Thank you carat1.
  0  
  0  
#3
Options
Re:Networking questions with 2 ISP
2018-01-16 16:50:20
thanks a lot
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 1522

Replies: 3

Related Articles