T1600G-28TS and IGMPproxy
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
T1600G-28TS and IGMPproxy
Model :
Hardware Version :
Firmware Version :
ISP :
ISP
|
Firewall (pfSensewith IGMPproxy) (fw: 2.4.2)
|
TP 1600G-28TS(latest fw pr. last week. Will update later today)
|
Computers, IPTVdecoders
TP1600
Connected to Firwall using LAG (3 nics)
[*]IGMP snooping enabled
Ports FROM pfsense and TO devices/decoders configured as static IGMP ports
[*]VLAN 1 activated for IGMP and same ports as above confiured
Multicast table is populated with sessions when watching tv
Result:
IPTV starts to jerk/stutter after 10 seconds and stops completely after about 30 seconds
Mitigation:
Enable "multicast vlan"
[*]Requires all traffic/ports to be reconfigured for a new vlan as vlan 1 cannot be a multicast vlan
Question:
Shouldn't this setup work without defining a "multicast vlan"?
Best regards,
Ulf Thomas
Hardware Version :
Firmware Version :
ISP :
ISP
|
Firewall (pfSensewith IGMPproxy) (fw: 2.4.2)
|
TP 1600G-28TS(latest fw pr. last week. Will update later today)
|
Computers, IPTVdecoders
TP1600
Connected to Firwall using LAG (3 nics)
[*]IGMP snooping enabled
Ports FROM pfsense and TO devices/decoders configured as static IGMP ports
[*]VLAN 1 activated for IGMP and same ports as above confiured
Multicast table is populated with sessions when watching tv
Result:
IPTV starts to jerk/stutter after 10 seconds and stops completely after about 30 seconds
Mitigation:
Enable "multicast vlan"
[*]Requires all traffic/ports to be reconfigured for a new vlan as vlan 1 cannot be a multicast vlan
Question:
Shouldn't this setup work without defining a "multicast vlan"?
Best regards,
Ulf Thomas
