Model :

Hardware Version :

Firmware Version :

ISP :

Hi there,

I have a wireless link between 2 buildings using 2 CPE510's. I ran one in Access Point mode, and one in Bridge mode, got them connected and all had been working fine for nearly a year (341 days was the uptime when I logged into one of the devices)

SO I have a corporate LAN on Side A, which has one of the devices attached operating in Access Point Mode. The second unit is in a building on the opposite side of the street, the units are about 30 feet in the air on Poles and are in direct line of site of each other. Side B is configured as the Bridge, which is plugged into a switch which has a couple of devices attached (A CCTV DVR which I am trying to connect to)

I have updated firmware on both units, reset to factory defaults and tried re-configuring, only to receive the same result. I also tried running one device in Access Point mode and one in Client mode, still same result.

As I said, all had been working fine for nearly a year, when I plug a laptop into the network on Side A, I can see, ping and login to device on Side A, but can see nothing on side B. When I plug the laptop into switch on Side B, I can see the devices on that LAN (CCTV DVR etc) and the CPE510 on Side B, plus I can also ping the CPE510 on Side A, but nothing else on the network of Side A.

I am wondering if there has been some sort of failure somewhere in one of the devices, I have attached screen shots of of the config and status pages of both units.

Any help would be gratefully received.

Regards,
Mark Painting