EAP wireless bridge (Mesh)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Dear Community,
I read a lot of threads but i didn't find a detailed instruction.
I want to connect two EAP 225 wirelessly (wireless bridge perhaps 50 meters) to get Internet into a building where my device which need Internet is located.
Like this one: https://community.tp-link.com/en/business/forum/topic/251626
Setup: Internet -> Modem -> Switch -> Switch -> PoE -> EAP 225 )))))))) EAP 225 - PoE -> Device
-> wired
)))) wireless
EAP 225 (AC1200) V3 - 4. .... build
My problem is the configuration. I don't find the mesh function in the Omada software controller (lastest Version v5.9.31).
Do i have to connect the 2 EAP 225 in the same network wired first and then disconnect one of them to get a wireless bridge between them?
Everytime i connect via Wlan with one EAP - i can only config. this one. But there is also no mesh function to enable....
Mfg
