Model : T2600G-28TS

Hardware Version : V2.0

Firmware Version : 2.0.0 Build 20170928 Rel.34921(s)

ISP :

Hi all,

last week i bought a T2600G-28TS 2.0 for home use. I monitor all my devices in Observium and was pleased to read the the T2600G supported up to SNMP V3. However...........it only returns correct results on SNMP V1.
If i read the device with V2 or V3, all interfaces are marked as "deleted" and no graphs are built. If i do a manual snmpwalk the output always ends with : Error in packet. Reason: (genError) A general failure occured

Software running: 2.0.0 Build 20170928 Rel.34921(s)

SNMP V1 isn't preferred when using 1G interfaces as i would like to use 64-bit counters........
Anybody seen the same thing perhaps??

Thanks!