Ofloo_ wrote

Just recently bought new switch T1500G-10PS v2.0 for up link  I setup static lag of sfp, .. over fiber and over copper I only get 2~10mbit speed when i check the linking speed of the connections it says 1000M full duplex. Using latest and only firmware, there is no new release since it has been released.

 

As far as i can tell all bandwidth control and qos are disabled, there still factory settings.

Hi Ofloo：

     How do you do the test?

     This issue like your device is not compatible with T1500G-10PS. Did you change the different devices do the test?

Ofloo_ wrote

Just recently bought new switch T1500G-10PS v2.0 for up link  I setup static lag of sfp, .. over fiber and over copper I only get 2~10mbit speed when i check the linking speed of the connections it says 1000M full duplex. Using latest and only firmware, there is no new release since it has been released.

 

As far as i can tell all bandwidth control and qos are disabled, there still factory settings.

It seems you have links 100/half or 10/half somewhere. Firstly, check on copper wires without LAG. Configure everywhere, where possible auto/auto (speed/duplex on network card, both sides links). If you have 100Mbps uplink, then configure manually 100/full. Check all cables.