JetStream cli SSH/telnet paging issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

JetStream cli SSH/telnet paging issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
JetStream cli SSH/telnet paging issue
JetStream cli SSH/telnet paging issue
2019-01-20 22:18:37 - last edited 2019-02-14 22:59:44

Hi there,

 

Im trying too automate my switches but because of paging “press any key to see more” this is not going well.

 

for business rated switches why isn’t there a option to disable paging? I’m quite certain there are many more people who think that too.

  0      
  0      
#1
Options
1 Accepted Solution
Re:Re:JetStream cli SSH/telnet paging issue-Solution
2019-02-14 22:27:04 - last edited 2019-02-14 22:59:44

TP-Link replied:

 

"Our switches that have the new web-UI support to disable paging. Such as T2600G-28TS V3, T1600G-28TS V3.

But T1700G-28TQ V3 doesn't support currently, It will add this feature in the next firmware version."

 

For the T2600G-28TS V3, T1700G-28TQ V3, T1600G-28TS V3 the command is "no clipaging" in config mode.

Recommended Solution
  0  
  0  
#3
Options
2 Reply
Re:JetStream cli SSH/telnet paging issue
2019-01-21 07:59:10

mHagen wrote

Hi there,

 

Im trying too automate my switches but because of paging “press any key to see more” this is not going well.

 

for business rated switches why isn’t there a option to disable paging? I’m quite certain there are many more people who think that too.

 

Hi mHagen

   

    For this, you need contact with TP-LINK. For the general firmware, I think they do not support the command as Cisco.

  0  
  0  
#2
Options
Re:Re:JetStream cli SSH/telnet paging issue-Solution
2019-02-14 22:27:04 - last edited 2019-02-14 22:59:44

TP-Link replied:

 

"Our switches that have the new web-UI support to disable paging. Such as T2600G-28TS V3, T1600G-28TS V3.

But T1700G-28TQ V3 doesn't support currently, It will add this feature in the next firmware version."

 

For the T2600G-28TS V3, T1700G-28TQ V3, T1600G-28TS V3 the command is "no clipaging" in config mode.

Recommended Solution
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 1553

Replies: 2

Related Articles