difference by enable between telnet and ssh on T1700G-28Q

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

difference by enable between telnet and ssh on T1700G-28Q

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
difference by enable between telnet and ssh on T1700G-28Q
difference by enable between telnet and ssh on T1700G-28Q
2018-05-14 14:18:32
Model :

Hardware Version :

Firmware Version :

ISP :

Hallo,

some days ago I by a new T1700G-28Q and wonder for difference after enable by access over telnet vs. ssh. Over telnet I get the full access with configure and so on. But I don't like telnet because of security. By using ssh I can't configure:

---snipp
tp-link>enable

tp-link#
broadcast - Write message to all users logged in,
enable-admin - Achieve the admin privilege
logout - Logout the system
ping - Ping command
clear - Reset functions
exit - Exit current mode
show - Display system information
----

What can I do?

with regards
gigaliner
  0      
  0      
#1
Options
2 Reply
Re:difference by enable between telnet and ssh on T1700G-28Q
2018-05-15 17:58:48

gigaliner wrote


some days ago I by a new T1700G-28Q and wonder for difference after enable by access over telnet vs. ssh. Over telnet I get the full access with configure and so on. But I don't like telnet because of security. By using ssh I can't configure:


You are looking in the wrong menu level. Try:

[CODE]Core Switch>enable
Core Switch#enable-admin
Core Switch# ?
broadcast - Write message to all users logged in,at most 256 characters
configure - Enter Global Configuration Mode
copy - Config file commands
debug - Debugging commands
enable-admin - Achieve the admin privilege
firmware - Firmware commands
logout - Logout the system
ping - Ping command
reboot - Reboot the system
remove - Config file commands
reset - Reset the system
tracert - Tracet route to destination
clear - Reset functions
exit - Exit current mode
history - Display command history
show - Display system information
Core Switch#[/CODE]
༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options
Re:difference by enable between telnet and ssh on T1700G-28Q
2018-05-16 02:33:48
Many of thanks R1D2. That is was I feared. So I must configure AAA. But it wasn't so terrifyingly :) and now I can configure over ssh too.

with regards
gigaliner
  0  
  0  
#3
Options