Diesnnox wrote

Hi All,

I have a problem, we replace old cisco routers to TL-ER6020, one in Vancouver another in India.

Before changing it was 2 Cisco rv130w routers with configured ipsec lan-to-lan works fine.

Now I try to configure lan to lan on new routers and it didn’t work.

Below I put configuration.

1. Can it be because I configure first router (no VPN Config) save config and restore it on another one (Change ip and etc, but do not change Vlan id)?

 

1. Is any way to get more detailed log from TL-ER6020?

 

1. Just need help.

 

Hi Diesnnox

When you restore the config file from a router to another router, the router that restore the config may change the MAC address. Please try to check the MAC address of both routers. If they use the same MAC address, please reset the router configure it manually.

Hi,

Make story short, I check MAC on routers it is a different, as I change it once configure for static public IP.

With no luck establish tunnel for a day, I just reset one of the routers and make all config manually. Once I done with that, tunnel was established.

So, the cons will be like that tp-link routers are not ok for mass deploying by copy base config as it causes issues.

But still question is How i can get more detail from router log?

Diesnnox wrote

But still question is How i can get more detail from router log?

Hi Diesnnox

About the MAC will changed when restore the config file of other routers, TP-Link will consider to change it in the next version.  

About the system log, please choose all levels as Severity. All logs will display in the log list. And it's the all information for log.