SYS LED blinking on TP-Link 2600G-52ts managed switch
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
SYS LED blinking on TP-Link 2600G-52ts managed switch
Hi after opening and connecting to the web gui of the managed switch I've tried to configure some setting but after turn off the IPV6 enable settings..then I can't connect to the switch... I can't even ping it... I tried rebooting the switch then noticed that the SYS LED starts blinking.. That means the switch is improperly working right? Any help or tips?
Edit: so finally after rebooting a lot , we managed to open the GUI but the SYS LED is still blinking.. we tried to restore to factory default but its still blinking..
