EAP110 Outdoor - Power
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Ok excuse my ignorance I have done some research on the internet but can my EAP110 Outdoor be powered solely from a POE Network switch OR do you HAVE to use the power adaptor that came with it
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
This access point only supports 24volt passive poe, so you cannot use a POE network switch on this device.
Ref.
https://www.tp-link.com/no/support/faq/906/
- Copy Link
- Report Inappropriate Content
waulkmill wrote
Ok excuse my ignorance I have done some research on the internet but can my EAP110 Outdoor be powered solely from a POE Network switch OR do you HAVE to use the power adaptor that came with it
You can either use the included 24V power injector or a PoE switch which supports passive PoE (24V) such as EdgePoint R6 for example. I run EAP110-Outdoor on EP-R6, which is actually a router, but can be configured as a switch, too. You can not use IEEE 802.3af/at PoE switches, which operate at 48V.
- Copy Link
- Report Inappropriate Content
Many thanks for your most helpful reply
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1561
Replies: 4
Voters 0
No one has voted for it yet.