I have pfSense virtualized on ESXi inside of a Intel Nuc.  Everything works with pfSense as a standalone router on one LAN. 

I decided to get a TP-Link TL-SG108PE because I wanted a relatively inexpensive smart POE switch that could do VLANs for my home lab.  In pfSense I have my main network set to 192.168.30.1/24 and a VLAN (VLAN50) that I call "Guest" set to 192.168.50.1/24.  I obviously have DHCP running on the VLAN so that devices on the guest network can get an IP.  

I have a TP-Link EAP 225 connected to port 1, my PC connected to port 2, and my pfSense connected to port 7.  

My VLAN config is below, but I have ports 1 and 7 tagged for VLAN 50 and port 8 untagged for VLAN 50.  I also have the PVID on port 8 set to 50.  

My probelm is that when I connect my PC to port 8, which should get an IP in the 192.168.50.1/24 range, I simply don't get any IP address, and when I create a wireless network that runs off of said VLAN on my EAP225 I don't get an IP either.  I did some testing on the pfSense side (I went to diagnostics and was able to ping the VLAN gateway). 

Am I missing something here? Any help would be greatly appreciated!