T1600G-52TS Ip conflict

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

T1600G-52TS Ip conflict

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
T1600G-52TS Ip conflict
T1600G-52TS Ip conflict
2019-12-04 16:20:08
Hardware Version:
Firmware Version:

Hello,

I have changed the switch IP address because it was the same ip for my local domain.

For some reason, sometimes the switch changes his ip to the default, and ip conflict occurs and shutsdown network services.
I don't use DHCP, my network is all static ip.

How can i prevent this? What is going on with the switch?

 

Best Regards.

 

  0      
  0      
#1
Options
4 Reply
Re:T1600G-52TS Ip conflict
2019-12-04 16:57:47 - last edited 2019-12-04 17:00:38

Hi @jbaptista,

 

if the switch changes its IP after a reboot/power failure, make sure to save the config (see the »Save« button on the top right side in the new or bottom left menu item in the old web UI.

 

New web UI:

 

Older web UI:

 

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options
Re:T1600G-52TS Ip conflict
2019-12-04 17:05:18

@R1D2 There is no power shutdown. I have done save, it has been working for a few months, but sometimes theres conflict ip.
It shutsdown our network, people stop working. I don't know what is going on with this switch. 

  0  
  0  
#3
Options
Re:T1600G-52TS Ip conflict
2019-12-04 19:28:55

@jbaptista, I suggest to contact TP-Link support directly through your country's TP-Link website.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#4
Options
Re:T1600G-52TS Ip conflict
2019-12-05 12:32:24

@R1D2 This switch is in L3 Features -> Interface -> Edit IPV4.

I have reconfigured again, i'm not sure if i did SAVE or just APPLY.

This time i made both, i did apply first, changed my laptop address, logged in again, and made save.

I shutdown the switch, and checked his ip address, it keept the correct IP.
Let's see how this goes now.

 

Thanks you all for your help.

  0  
  0  
#5
Options