Link Backup Issue In TP Link R480T + Load Balancer

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Link Backup Issue In TP Link R480T + Load Balancer

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Link Backup Issue In TP Link R480T + Load Balancer
Link Backup Issue In TP Link R480T + Load Balancer
2020-03-25 11:47:49 - last edited 2021-04-19 11:24:42
Model: TL-R480T+  
Hardware Version: V9
Firmware Version: 9.0.2 Build 20180926 Rel.34538

Hi everyone!

 

Could someone help me?

 

I followed the manual of TP Link R480T+ to setup an failover for WANs as image bellow shows. It works fine literally when WAN1 fails the WAN2 assumes. However when WAN1 comes up the WAN2 continues working. I didnt not found nothing on manual or forum about this.

- WAN1 is better, fibrechannel, 50Mb full

- WAN2 is precarious, wireless, 6Mb download - 3Mb upload

- Online Detction setting is: Manual, Ping 8.8.8.8, DNS Lookup 8.8.4.4

 

  0      
  0      
#1
Options
1 Reply
Re:Link Backup Issue In TP Link R480T + Load Balancer
2020-03-26 02:11:34 - last edited 2021-04-19 11:24:42

@madleme 

 

Please confirm if you have enabled load balance. As I knew, for TP-Link should enable load balancing then link backup will take effect.

 

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 955

Replies: 1

Related Articles