Apple Macbook can't find the SSID
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello, while installing my new bought EAP110, my Apple Macbook can't find the SSID of the EAP110.
Is it the fould of my Laptop? Or am I doing something else completely wrong?
Thanks, Mark from The Netherlands
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@MarkMeij, did you set up and enable the EAP's SSID by logging into the web UI the first time or if using the Omada controller did you define a SSID?
If so, do you use non-standard characters in the SSID? Can any other device find the SSID?
We would need a bit more information about what you were doing exactly to be able to help.
- Copy Link
- Report Inappropriate Content
Thank for the reply, I'm a little new to this, and I'm trying to translate some of your phrases to Dutch to understand a little more.
I was installing the EAP110, I did it before in my parents house, now in my own appartment, but I can't figure out what I am doing wrong. The light on the EAP is solid green, no flasing or whats so ever. I used different LAN ports on my router, switched of the power multiple times.
When I open the Wifi settings on my laptop, the SSID doesn't appear. Not on my laptop, not on my girlfriends laptop, and none of our iPhones.
I tried to download the Omada app, but that doesn't make sence either. I tried to use: search for other networks, and typed the SSID, but... Not found.
Hope thats enough info.
Mark
- Copy Link
- Report Inappropriate Content
so you didn't configure the EAP110?
You need to set at least a password for access to the EAP's web interface in order to turn the WLAN on. To do so:
- Connect the EAP to your laptop/PC by cable.
- Set your laptop's IP address to 192.168.0.10.
- Connect to the EAP by addressing the web interface in a browser using http://192.168.0.254.
- Set up the username, password, SSID.
- Disconnect the EAP from the laptop and plug it into your network.
- Change back the IP of your laptop t what it was before (dynamic IP address/DHCP most probably).
Dus je hebt de EAP110 niet geconfigureerd?
U moet ten minste een wachtwoord instellen voor toegang tot de webinterface van de EAP om het WLAN in te schakelen. Om dit te doen:
- Sluit de EAP via de kabel aan op uw laptop/PC.
- Stel het IP-adres van uw laptop in op 192.168.0.10.
- Maak verbinding met de EAP door de webinterface in een browser aan te spreken via http://192.168.0.254.
- Stel de gebruikersnaam, het wachtwoord en de SSID in.
- Koppel de EAP los van de laptop en sluit deze aan op uw netwerk.
- Verander het IP van uw laptop terug naar wat het was (dynamisch IP adres/DHCP waarschijnlijk).
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 659
Replies: 3
Voters 0
No one has voted for it yet.