AP's not displayed on map

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AP's not displayed on map

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
AP's not displayed on map
AP's not displayed on map
2020-04-10 10:27:53
Model: OC200  
Hardware Version:
Firmware Version: 1.2.1 Build 20191126 Rel.59455

So I decided to use coverage maps.   I do not see my AP on the map.  there is a button "Unplaces AP's" but nothing is there...  I am guessing it is possible it was dragged off the screen but I cant find it..

  0      
  0      
#1
Options
4 Reply
Re:AP's not displayed on map
2020-04-10 15:17:51 - last edited 2020-04-10 15:19:26

@Reef-a-Holic, EAPs cannot be placed off the map canvas completely.

 

Check whether it might be on a different map. You can define more than one map per site. Also set minimun zoom factor (see red arrow).

 

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options
Re:AP's not displayed on map
2020-04-10 19:30:25 - last edited 2020-04-10 19:30:49

@Reef-a-Holic I only had the default map set up.   Finally did a factory reset and it came up.  Not sure where it went..Thanks for the replies

  0  
  0  
#3
Options
Re:AP's not displayed on map
2020-04-11 12:18:39

@Reef-a-Holic, I noticed during tests that devices casually can disappear when one is connected to the controller through the TP-Link cloud and the connection times out. In this case, a reload of the web page causes device icons to re-appear on the map. Of course, forgetting the EAP and re-adopting it helps, too.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#4
Options
Re:AP's not displayed on map
2020-04-11 16:18:42

@Reef-a-Holic Thanks for the replies.   The page reloading and even switching browsers did not help.  The only thing that did was a factory reset.

  0  
  0  
#5
Options

Information

Helpful: 0

Views: 1014

Replies: 4

Related Articles