802.1x details not displayed

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

802.1x details not displayed

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
802.1x details not displayed
802.1x details not displayed
2022-02-12 16:51:28 - last edited 2022-08-31 08:42:57
Model: OC200  
Hardware Version: V1
Firmware Version: 5.0.30

Hi,

 

I'm using WPA Enterprise with Dynamic VLAN enabled.

However, when client connects to the wifi, 802.1x and the associated VLAN column are not displayed in the client section nor the overview section of the device.

 

cf0dd6ea1575497da1b348161ab7c318

  0      
  0      
#1
Options
1 Accepted Solution
Re:802.1x details not displayed-Solution
2022-02-21 08:02:08 - last edited 2022-08-31 08:42:57

Dear @pokhui,

 

pokhui wrote

I'm using WPA Enterprise with Dynamic VLAN enabled.

However, when client connects to the wifi, 802.1x and the associated VLAN column are not displayed in the client section nor the overview section of the device.

 

Thank you for your valued feedback!

 

In fact, the two columns of 802.1X Authentication and 802.1X VLAN on the Clients page refer to the 802.1x info for the wired clients on the Switch. The wireless clients don't have such information since the AP cannot report the 802.1x related VLAN and status.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:802.1x details not displayed-Solution
2022-02-21 08:02:08 - last edited 2022-08-31 08:42:57

Dear @pokhui,

 

pokhui wrote

I'm using WPA Enterprise with Dynamic VLAN enabled.

However, when client connects to the wifi, 802.1x and the associated VLAN column are not displayed in the client section nor the overview section of the device.

 

Thank you for your valued feedback!

 

In fact, the two columns of 802.1X Authentication and 802.1X VLAN on the Clients page refer to the 802.1x info for the wired clients on the Switch. The wireless clients don't have such information since the AP cannot report the 802.1x related VLAN and status.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
Re:802.1x details not displayed
2022-03-11 14:15:54

  @Fae I suppose the AP should know the username and the Dynamic VLAN assigned value on the wireless client is it's using WPA Enterprise with RADIUS. It will help a lot to identify which device belongs to which user in the Client page.

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 577

Replies: 2

Related Articles