Business Community > All Threads > How to setup a LAG (LACP) link between 2 switches (T1600G-28PS(TL-SG2424P))
< All Threads

How to setup a LAG (LACP) link between 2 switches (T1600G-28PS(TL-SG2424P))

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to setup a LAG (LACP) link between 2 switches (T1600G-28PS(TL-SG2424P))

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to setup a LAG (LACP) link between 2 switches (T1600G-28PS(TL-SG2424P))
How to setup a LAG (LACP) link between 2 switches (T1600G-28PS(TL-SG2424P))
2020-04-27 08:54:25
Model: T1600G-28PS(TL-SG2424P)  
Hardware Version:
Firmware Version:

Hello Everyone,

 

We are really struggling with setting up a LAG between our 2 switches.

 

When setting the LAC up (static or LACP) the network goes down immediately (probably broadcast storm).

 

We have set the LAG up according to the TP-link instructions given in the manual and online forums.

 

In the MENU, we went to L2 features, LAG and have chosen LACP.

 

Group ID 1 - enable - 32768 - Active and have chosen ports 23 en 24

 

on the second witch we have done the same and chosen ports 1 and 2.

 

Immediatly after hitting save, the network goes down with the 2 links inserted...  configuring a static LAN gives the same result.

 

Has someone more experience with this setup ?

 

thanks,

David

  0      
 
  0      
 
#1
Options
1 Reply
Re:How to setup a LAG (LACP) link between 2 switches (T1600G-28PS(TL-SG2424P))
2020-04-29 03:03:10

@DCO_GROUP_BV 

 

You can check the LED to confirm whether it's a broadcast storm. If the LED did not flash quickly. I think your problem may be caused by the setting for LAGS. 

For tp-link switch, after you set up LAG, you need to re-configure layer 2 function for LAG group. The original configuratrion for the switch ports will out of action. So you lost network maybe because you haven't configured layer2 function for LAG group.

The following is the FAQ for configuration VLAN for LAG. Other layer2 function is similar.

https://www.tp-link.com/en/support/faq/2396/

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1832

Replies: 1

Related Articles
Linking 2 T1600G-28PS switches
1007 0
SG2210P LAG LACP ?
835 0
TP-Link T1600G-28PS with TP-Link EAP225 WAP and 3 SSIDs each using their own VLAN - 1 works 2 don't
1563 0
Need some guidance on VLAN setup
2219 0
coupling switches
831 0
LAG = LACP IEEE 802.ad ?
401 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.