EAP225-outdoor powering from a 24V battery source
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP225-outdoor powering from a 24V battery source
Hello all,
I need to power up a few EAP225-outdoor from a 24V battery source.
The product comes with a passive mains to PoE adaptor. That's great, but not of much help for my application.
My idea is to make a PoE injector, but I'm not sure what voltage and on what pins of the RJ45 connector I have to inject the dc voltage.
Any suggestions for that.
Thanks
Ju
1 Accepted Solution
Re:EAP225-outdoor powering from a 24V battery source-Solution
Dear @jgnoss,
It's highly recommended to use the provided power supply to power up the EAP products, otherwise, it may damage the product.
- Any defects or damages caused by improper installation or misuse could avoid the product warranty.
>> Omada EAP Firmware Trial Available Here <<
*Try filtering posts on each forum by Label of [Early Access]*
Re:EAP225-outdoor powering from a 24V battery source-Solution
Dear @jgnoss,
It's highly recommended to use the provided power supply to power up the EAP products, otherwise, it may damage the product.
- Any defects or damages caused by improper installation or misuse could avoid the product warranty.
>> Omada EAP Firmware Trial Available Here <<
*Try filtering posts on each forum by Label of [Early Access]*