Clients not showing up with EAP connected on same switch
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Clients not showing up with EAP connected on same switch
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I have 1xOC200 / 1xTL-R605 /1xTL-SG2008P / 3xEAP265 in my omada environment.
I have two none omada(management) TP-LINK switches connected to a port on the SG2008P. Both switches have different clients and a EAP265 connected.
The clients on the two switches are not shown in the clients section.
When i disconnect the EAP265 the clients are shown and when i connect the eap265 the clients are nog showing up anymore(the clients on the same switch from which i connect / disconnect the EAP265).
Because the same problem occurs with different switches / cables / eap i suspect the omada software suspress the cliënts?
Best regards,
Michel
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Fae Doesn't seem to do anything for me
- Copy Link
- Report Inappropriate Content
@Fae upgraded both and issue is still the same.
- Copy Link
- Report Inappropriate Content
@Fae Any update? This is quite easy to reproduce and a very annoying issue. I would really like to see this fixed!
Don't make me regret switching from Ubiquiti...
- Copy Link
- Report Inappropriate Content
I have the new version of the controller software running (4.2.11) and still seeing this issue with some network devices not showing up in the clients tab. I am running the controller on a Windows pc with 6 eaps attached through a tp link poe switch and an r605 router managed through the controller software.
- Copy Link
- Report Inappropriate Content
Hi All,
For the issue that Wired Clients not showing up with EAP connected on the same switch whose network topology is
Wired Clients & EAP ---- non-Omada managed switch ---- Omada network
The issue has been addressed and it will be fixed in Omada Controller v4.3 (developing).
- Copy Link
- Report Inappropriate Content
@Fae I have installed the latest version of the controller but same issue. Do we have to wait for the new firmware of the switch?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 4344
Replies: 16
Voters 0
No one has voted for it yet.