Moving from Software to Hardware Controller
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Moving from Software to Hardware Controller
Has anyone made the move from a software version of the Omada Controller to the hardware version? Any tips or issues you ran into?
I have the software running on an old computer right now but intend to repurpose that so thinking of grabbing the OC200 and moving my configuration over to that one. Worried about my network getting trashed in transition; not sure if I can load the OC200 up on the side, give it a backup of the config from the software controller, THEN switch them out?
1 Accepted Solution