How to Verify Load Balancer is working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to Verify Load Balancer is working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to Verify Load Balancer is working
How to Verify Load Balancer is working
2021-04-15 12:42:27 - last edited 2021-04-16 09:12:54
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version:

Hello Community , 

 

I recently set a ER605 with Two ISP on WAN and WAN/LAN1 . 

 

 

I have also enabled Load Balancing and Link Backup

 

How do I determine that the Load is now being balanced between two connections

 

I was able to see  that the Link Failover is working when one ISP is down . It does take 6-7 Seconds and traffic resumes 

 

How do I see Load balancing is working and Traffic is getting sent to both ISPs

 

 

Appreciate any Guidance. 

  0      
  0      
#1
Options
2 Reply
Re:How to Verify Load Balancer is working
2021-04-18 08:43:03

Dear @iVaibhav,

 

iVaibhav wrote

I recently set a ER605 with Two ISP on WAN and WAN/LAN1 . 

I have also enabled Load Balancing and Link Backup

How do I determine that the Load is now being balanced between two connections 

I was able to see  that the Link Failover is working when one ISP is down . It does take 6-7 Seconds and traffic resumes  

How do I see Load balancing is working and Traffic is getting sent to both ISPs

 

If you have set up the Link Backup function, then only one WAN are online and used for Internet connection while the other WAN is always standby(offline). If you want both WAN connections work at the same time, please disable Link backup function and simply keep the Load Balancing enabled, for more details about Load Balance feature, you may read this thread.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:How to Verify Load Balancer is working
2021-04-18 17:59:46

@Fae 

 

Thanks for your Response, 

 

I have Link Backup Disabled and only Load Balancing Enabled, Now How do I check if its really working and both links are now being used in traffic ?

 

Should I expect double speed 

 

or Should I expect zero downtime as traffic is divided on both links. 

 

How do I conclude that load balancer is working fine ?

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 1321

Replies: 2

Related Articles