Get an error "Not enough ACL hardware entry" when I bind an ACL to port of a SG2428p
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Get an error "Not enough ACL hardware entry" when I bind an ACL to port of a SG2428p
Hi,
I created an ACL list with 54 IP Subnet addresses (Combined ACL). (including network address and the related Subnet mask)
The next step was to bind that ACL list to several ports of a SG2428p (without controller).
So I get always the following message "Not enough ACL hardware entry"
I have checked the specifications of the switch and found for ACL support "Support up to 230 entries"
What is wrong and why I get that message?