How do I set a static ip on my TL-SG2210MP switch with the OC200 controller?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How do I set a static ip on my TL-SG2210MP switch with the OC200 controller?
I am not an expert at networking and for sure not with Omada. I'm learning about the Omada software as I go along.
I was wanting to know how I set my TL-SG2210MP switch to static ip using the OC200 controller? I just can't seem to find the spot where it is located? Is there a video, or a description some where that I am missing? Thanks.
Re:How do I set a static ip on my TL-SG2210MP switch with the OC200 controller?
Hey
Its easy enough to do, but a bit of a strange place
Go to DEVICES
select the SG2210MP
On the popup menu on right, go to CONFIG and VLAN Interface
You will see a list of VLANs, select the one your switch is registered on (likely LAN) and click the EDIT button
In there you can set the IP