Business Community > All Threads > Unable to connect to new TP-Link device
< All Threads

Unable to connect to new TP-Link device

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Unable to connect to new TP-Link device

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Unable to connect to new TP-Link device
Unable to connect to new TP-Link device
2021-08-26 06:00:29 - last edited 2021-08-27 01:12:35
Model: CPE510  
Hardware Version:
Firmware Version:

Hi

 

I recently purchased 2x CPE510's via Take A Lot. The 1st one I managed to access and configure without any issues. The second one, however, I cannot access at all:

 - Lan and Power LED's are burning

- I can default / reset the unit via both default buttons on unit itself, and on POE adaptor

 - I can ping my own Ethernet address  (192.168.0.9)

 -- but when i ping 192.168.0.254, i get " ....destination host unreachable"

 - it is not showing in my arp table

 - I swapped all cables , POE adaptor, even tried another laptop to connect

 

All of the above works fine on the "first" unit.

 

Please help

Hoitsema

 

  0      
 
  0      
 
#1
Options
5 Reply
Re:Unable to connect to new TP-Link device
2021-08-27 07:20:59
Did you try accessing the second CPE via Ethernet connection and static IP? If you connect your laptop wirelessly, you may experience IP conflict because both CPE have the same default IP as 192.168.0.254.
  0  
  0  
#2
Options
Re:Unable to connect to new TP-Link device
2021-08-31 04:56:58

@Hoits  Hi 

 

Thank you for your response. 

 

Yes, I used an Ethernet cable with static IP (for both)

  0  
  0  
#3
Options
Re:Unable to connect to new TP-Link device
2021-09-02 08:10:48
You can change one of the CPE to 192.168.0.253 to avoid IP conflict.
  0  
  0  
#4
Options
Re:Unable to connect to new TP-Link device
2021-09-02 10:28:34

@Hoits 

 

Hi

 

I have only one device active at a time. The other unit is powered down ro eliminate duplicate iip address issues. I also tried 2 separate laptops to eliminate potential ARP issues

 

H

  0  
  0  
#5
Options
Re:Unable to connect to new TP-Link device
2021-09-03 06:07:16 - last edited 2021-09-03 06:08:58

@Hoits 

 

When you connect the laptop to the LAN port of POE, can you see the LAN light on the CPE come on? Check if all physical connections are good. Try shorter cables.

  0  
  0  
#6
Options

Information

Helpful: 0

Views: 778

Replies: 5

Related Articles
i am unable to connect with the wifi to any of my device
420 0
Device unable connect
585 0
Unable to attach to TP-link
804 0
TP Link WAP : Unable to connect to router
822 0
i unable to connect my access point. i unable to go login page of my AP
891 0
Set up outdoor CPE and its only allowing one device to connect to wifi at a time
114 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.