TL-R480T+ point to point NATing issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-R480T+ point to point NATing issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-R480T+ point to point NATing issue
TL-R480T+ point to point NATing issue
2021-08-29 06:47:58
Model: TL-R480T+  
Hardware Version: V9
Firmware Version: 9.0.3 Build 20200313 Rel.38262

Hi all,

 

I need to control using SNMP commands à motor drive from my PC. The motor is 192.168.1.100, within the internet router address range.

 

So I had a R480+ to connect the motor :

 

 

Motor  : 192.168.1.100/24   <== NAT ==> 192.168.0.100/24

                                                 | WAN1

                                    <<< R480 >>>>

                                                 | LAN5

                                 PC : 192.168.0.50/24

                                     |

                                   WiFi

                                     |

                                 Internet

 

 

I have set up a one-to-one nating connection with theses parameters, but cannot ping or use SNMP between motor and PC (it work with crossover cable and Wifi "unconnected" on PC)

 

Any ideas ?

 

 

Frederic

                                 

File:
R480 Screenshoots.zipDownload
  0      
  0      
#1
Options

Information

Helpful: 0

Views: 443

Replies: 0

Related Articles