Port Forwarding for Server connected after Point to Point Bridge(WA-5210G)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Port Forwarding for Server connected after Point to Point Bridge(WA-5210G)
Region : Malaysia
Model : TL-R470T+
Hardware Version : V2
Firmware Version : 5.1.0 Build 20120510 Rel.58982s
ISP :
Currently I have two office which i connected the network with WA-5210G with Bridge (Point to Point) mode. I need to configure port forwarding for my CCTV where it works properly with the one connected directly to the Load Balancer. However i have issue setting up port forwarding for any network connected after the bridge.
Model : TL-R470T+
Hardware Version : V2
Firmware Version : 5.1.0 Build 20120510 Rel.58982s
ISP :
Currently I have two office which i connected the network with WA-5210G with Bridge (Point to Point) mode. I need to configure port forwarding for my CCTV where it works properly with the one connected directly to the Load Balancer. However i have issue setting up port forwarding for any network connected after the bridge.