Two questions about VIGI NVR1016H
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi.
I am a new user of VIGI NVR1016H, and have two issue:
1. After restart monitor connected to this NVR, picture is not back, monitor not receive video signal from NVR, although NVR still working correct. When I restart NVR, picture is back, and everything work perfect, how long I'm not turn off monitor.
2. How connect TP-LINK NC450-2 camera, to this NVR? Is this camera working with ONVIF standard (if Yes what is the port number)?
I tried the RTSP protocol by typing an address similar to the one that works with iSpy (Windows), unfortunately to no avail
Regards
Ok, first issue is probably my monitor, I do not have an HDMI socket in it and I use a DVI -> HDMI adapter, and I suppose there is a problem here.
Second issue, I can't connect TP Link NC450 v2 camera, to my NVR, by ONVIF protocol. I tried ports: 80, 8080, 2020, 3702 (I found information about the latter on the internet), I get an error every time.
I was able to connect the NC450 v2 using RTSP. The problem was with a misleading hint on the configuration page. You only need to enter the last entry of the access path, not the whole path (as suggested by the hint)
Unfortunately, the RTSP protocol does not allow to use PTZ, so if possible, please provide the correct ONVIF port for this camera
And I have one more question: How can I set the motion detection area?
I try to click on the image with the mouse, hold down the left button and move the cursor, but nothing is selected. The other keys also doesn't work, and the right one returns to the main NVR screen.
