Disable NAT
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @Mark_TSB
Could you please tell us why you need to disable NAT of the router?
You can use a switch to replace the router if you don't want NAT. But I don't think it is the thing you really require. NAT is a router's basic function and that's why a router is a "router".
Please note wtplink router does not support classic routing from WAN to LAN.
- Copy Link
- Report Inappropriate Content
@Mark_TSB Hi, we have a FORTIGATE firewall in front of TP-LINK, we don't see source <> destination packets. We need to use all TP-LINK features except firewall on all branches.
Mark
- Copy Link
- Report Inappropriate Content
I disagree @Hank21 :
Per definition a switch forwards packets at network layer 2: ethernet. A router forwards packets at network layer 3: IP.
NAT is not what makes a router a "router". A normal router is stateless an cannot NAT. Tracking connection state is a firewall functionality and thus NAT is also firewall functionality.
Residential network gateways that are commonly called routers are usually a combination of a modem (DOCSIS, DSL or PON) a router and a firewall with NAT all in one box. Since the Omada router (I got a TL-R605) does not have a modem I'm forced to use the residential network gateway provided by my ISP and since I only get one public IP I also have to use the NAT functionality of that gateway.
I have multiple IP networks/VLANs in my LAN which are routed by the TL-R605. However PC's directly connected to my residential gateway can not reach destinations on the TP-Link part of the network because NAT in the TP-Link Omada solution can not be turned of. There are two possible solutions:
1) Make it possible to disable NAT on a WAN port.
2) Make it possible to set a default route to a device on a LAN port. (Can't do that now. Setting a route to 0.0.0.0/0 fails. The route to 0.0.0.0/0 is the default route)
Please
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hello
i would also need the possibility to disable NAT in the Router. I have the same use-case as Mike_E.
Using a switch is also no solution, because the portalfunction on LAN-Ports needs an Omada Router to work (portal does not take effect if you do the routing on the switch).
With an Ubiquity ER-X you could disable NAT. But for the Omada-world with its gateway and the Portalfunction on LAN-Ports you absolutly need an Omada Router.
Additional info: The main-gateway can't be replaced by the Omadarouter, because of special functions of the main gateway.
@Hank21 @Fae,
could you please consider if disabling NAT could get on the roadmap?
Greetings
- Copy Link
- Report Inappropriate Content
This is a big problem. People wanting to switch from ubiquiti platform to omada will most likely not switch because of this.
I too have a Roqos RC150 SD Wan Appliance on the edge of my network and have the same problem.
Please TP-Link fix this quickly.
I should also note that TP-Link router model TL-ER6020 has this ability but it is not omada enabled. See below image.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 2904
Replies: 6