Hello,

I'm using Omada Software Controller with ER7206 V1.0 gateway and TL-SG2210P v5.0 managed switch .

All works good so far but when i try to disable ports on all protocols from 1057 to 65535 this is where all goes wild.

I have several Permit rules to allow traffic from specific devices to specific public IP addresses.

I even have a Permit rule locally from let's say 10.0.0.1/24 to ports 1057-65535 on 10.0.0.1/24 on all protocols (TCP, UDP, etc.)

Let's say the picture is as follows

1. VPN<->VPN

2. IPTV_CLIENT<->IPTV_SERVER

3. MGMT(10.0.0.1/24)<->MGMT_PORTS(10.0.0.1/24 - 1057-65535 All)

But when i add the last line

4. LAN (ALL VLANs) DENY -> Outbound 1057-65535 on all protocols the gateway is loosing it's adoption (DISCONNECTED) and never goes back while the switch stays CONNECTED.

Is there something i'm doing wrong (i don't believe it's the controller host firewall because until the Rule 4 in the Gateway ACL all is connected.

Any tips or ideas would be highly appreciated.