2
Votes

REPORTS->SSID->SSID Number Activities is pretty useless as-is

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
 
2
Votes

REPORTS->SSID->SSID Number Activities is pretty useless as-is

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
REPORTS->SSID->SSID Number Activities is pretty useless as-is
REPORTS->SSID->SSID Number Activities is pretty useless as-is
2022-05-09 21:22:03
Model: OC200  
Hardware Version: V1
Firmware Version: 5.1.7

Just noticed today that the count shown is an aggregate of the total number of SSIDs provisioned over all APs.  I think this graph would be a lot more useful if it graphed the number of AP's per active SSID, or even the number of active SSID per AP.  The key here being 'active'.  I have one profile with ALL of my SSID's for testing and other reasons, but I only ever enable 1-3 of them at a time.  Everytime I apply this profile to a new AP, the count in the below graph jumps by 6 (total # of SSID in profile payload), not the two that are actually active.  I think the graph would be much more useful if it graphed the # of APs actively serving say the top 8 or 10 SSIDs, one colour for each SSID.

 

 

 

 

<< Paying it forward, one juicy problem at a time... >>
#1
Options

Information

Helpful: 2

Views: 339

Replies: 0

Voters 2

voter's avatar
voter's avatar