EAP235-Wall / Not able to reset to factory defaults
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Got some hardware to start playing around with. Got an ER605, Controller, 2210P switch, and 2x AEP230-wall
I have configured it via the controller and it all seems to be working.
BUT I have difficulties with the EAP235. Whenever you move them from a port (example) port1 to port 3, the device is lost. It gives "no heartbeat" and one minute later it shows disconnected. Even when I put it back to the original port (3), it will not connect. (both devices have the same).
I tried to reset them to the factory defaults, BUT this doesn't work. Get a small metal pin, push the reset button for around 6 seconds, the light flashes, and when it stops flashing I release the reset button. Tried many other varieties, reset button for 6 seconds and when it flashes, I release it. But it doesn't do anything. I can find them on their IP, when I connect to them via the IP "tNote: This Gateway is being managed by Omada Controller 192.168.0.2"
I can see the EAP235 in the clients' TAB instead of the DEVICES. Even after many resets. Is there something I do wrong?
