Wired EAP235-Wall as mesh uplink?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wired EAP235-Wall as mesh uplink?
Can the eap235-wall be configured to act as an uplink device for a mesh connected AP (EAP225-outdoor)?
The mesh network has been configured through the Omada controller but the EAP-outdoor will only connect through the wired EAP610 as the uplink. Even if I enable auto failover and disconnect the EAP610, the meshed outdoor AP just disconnects, despite the wall AP being much closer and active.
Am I simply incorrect in thinking the EAP235-wall was capable of being an uplink device within a (partial) mesh network?
