ER605 (Standalone Mode) Reduce time of Switching WAN on disconnection

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 (Standalone Mode) Reduce time of Switching WAN on disconnection

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER605 (Standalone Mode) Reduce time of Switching WAN on disconnection
ER605 (Standalone Mode) Reduce time of Switching WAN on disconnection
2022-09-30 09:40:59
Tags: #Faster WAN Switching
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version: 2.0.2 (Beta)

Hi Everyone,

 

Note : Standalone Mode (Omada Controller not available).

 

My Question

---> How to reduce time of Switching WAN to WAN2 on Disconnection for Internet access.

       eg. When WAN1 gets disconnected it takes min 30 sec to switch to WAN2 (Both WAN1 and 2 ane broadband always on.). How to reduce it to 5 to 10 sec. I don't have an option of setting time in Online Detection menu.

 

 

  0      
  0      
#1
Options
2 Reply
Re:ER605 (Standalone Mode) Reduce time of Switching WAN on disconnection
2022-10-11 03:36:25

  @Shailesh_M  I encountered the same problem. But I found Omada Controller can modify the online detection interval

  1  
  1  
#2
Options
Re:ER605 (Standalone Mode) Reduce time of Switching WAN on disconnection
2022-10-22 12:36:47

  @HelsingL  Hi, i tryed Omada controller too, it had option to set switch WAN to WAN2 in few seconds but dispite setting it to 5 Sec it takes 20 Sec to switch to WAN2 its almost same as Standalone mode does.

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 852

Replies: 2

Tags

Faster WAN Switching
Related Articles