Business Community > All Threads > unable to get OC200 to connect to network
< All Threads

unable to get OC200 to connect to network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

unable to get OC200 to connect to network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
unable to get OC200 to connect to network
unable to get OC200 to connect to network
2022-11-19 19:03:57 - last edited 2022-11-25 05:25:04
Tags: #Controller Installation
Model: OC200  
Hardware Version: V2
Firmware Version:

I am just in the process of setting up replacements for my home network(upgrading to several TP-Link devices from colubris. I have 3 devices pluged in right now an OC200, EAP235 wall and eap 245. I can see the 2 AP but the OC200 is not pulling an IP from dhcp, I have checked on the switch it is connected to and it is on the correct vlan. and monitoring the port it is on I see no trafic coming form it. 

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:unable to get OC200 to connect to network-Solution
2022-11-23 12:59:04 - last edited 2022-11-25 05:25:04

  @cswilson it is connected to only a POE switch.  I Just resolved the issue this morning thou, it was the port security function on the switch its plugged into, it got flaged and the switch was blocking the mac from the switch

Recommended Solution
  0  
  0  
#4
Options
3 Reply
Re:unable to get OC200 to connect to network
2022-11-22 06:45:28

  @cswilson 

 

First make sure that the gateway is on the same network segment as the controller and that the controller is able to obtain a valid IP address.

If you make sure the DHCP Server is working properly, you can reset the controller and try again.

Just striving to develop myself while helping others.
  0  
  0  
#2
Options
Re:unable to get OC200 to connect to network
2022-11-23 08:28:00

  @cswilson this is not meant as an insult but the OC200 is receiving power through the USB or through POE and the power LED is illuminated?   I ask because I have seen a case of someone plugging the OC200 into a non POE switch but not powering it by USB.

  0  
  0  
#3
Options
Re:unable to get OC200 to connect to network-Solution
2022-11-23 12:59:04 - last edited 2022-11-25 05:25:04

  @cswilson it is connected to only a POE switch.  I Just resolved the issue this morning thou, it was the port security function on the switch its plugged into, it got flaged and the switch was blocking the mac from the switch

Recommended Solution
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 710

Replies: 3

Tags

Controller Installation
Related Articles
Unable to restore OC200 backup
996 0
Adding an OC200 to an already configured standalone network (cont'd)
623 0
OC200
316 0
OC200 unable to see EAP115 Access point
606 0
Cant access OC200 configuration
151 0
Unable to to connect the OC200 to cloud
1906 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.