Business Community > All Threads > ER605 IPSEC LAN to LAN VPN establishes connection but not routing traffic
< All Threads

ER605 IPSEC LAN to LAN VPN establishes connection but not routing traffic

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 IPSEC LAN to LAN VPN establishes connection but not routing traffic

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ER605 IPSEC LAN to LAN VPN establishes connection but not routing traffic
ER605 IPSEC LAN to LAN VPN establishes connection but not routing traffic
2022-11-29 20:38:49
Tags: #VPN
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version: 2.0.0

Hello,

 

I have an ER605 gateway set wtih an IPSEC LAN to LAN connection. It is set up behind another NAT gateway device. The tunnel is up and established, but I have no connectivity through the tunnel and I am unable to ping anything on the remote LAN. I'm assuming it is a routing issue but have so far been unable to figure out where the issue is. I understand this is a broad question, but any insight that can point me in the right direction would be very much appreciated!

 

Thank you!

  0      
 
  0      
 
#1
Options
2 Reply
Re:ER605 IPSEC LAN to LAN VPN establishes connection but not routing traffic
2022-11-30 11:11:18

  @Rico619 

 

You need to ensure that the WAN IPs of the two ER605s are able to communicate with each other.
This requires you to open the port for the WAN IP of the ER605 on the front NAT device and also open the port used by the IPsec protocol(It should be UDP 500/4500 if I remember correctly).

Just striving to develop myself while helping others.
  0  
  0  
#2
Options
Re:ER605 IPSEC LAN to LAN VPN establishes connection but not routing traffic
2023-05-05 09:59:24

@Rico619 Did you have a solution for this?  I am seeing the same behaviour on a number of ER605, the tunnel is definitely up but it's not routing traffic through that tunnel.  I created a second tunnel to another location and that one is absolutely fine when I bring it up.  Definitely nothing wrong with the tunnel config either, the same config is working on others. 

  1  
  1  
#3
Options

Information

Helpful: 0

Views: 1213

Replies: 2

Tags

VPN
Related Articles
VPN lan to lan not ping
1634 0
VPN LAN-LAN and LAN-USER at same time
494 0
VPN IPSec LAN-to-LAN
127 0
Lan-Lan IPsec tunnel with two ER605, each behind ISP routers
573 0
ER605 L2TP Client to Lan not working
547 0
VPN IPSEC IKEv2 on er605 v2
2376 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.