VLANs no longer working after firmware update(s)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.VLANs no longer working after firmware update(s)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I updated the firmware on my three switches (TL-SG2008 v3.0, TL-SG2210MP v1.0, TL-SG2008P v1.0) and after the update, devices on custom VLANs are either not assigned an IP address or are assigned an incorrect IP address. Testing on one of the servers I'm unable to ping the gateway (TL-R605) and when I try to renew the ip it tells me it's unable to reach the DHCP server. I tried rolling back the firmware upgrades, but that did not resolve the problem. I have removed and re-adopted all the switches, tried different configurations of switches and ports, removed, reset, and re-adopted the gateway, updated the TL-R605 to the latest beta firmware, all to no avail. I worked with TP Link support for a few hours and they were unable to solve the problem either. At this point the only functional devices are those on the LAN network. Any suggestions on potential solutions or strategies to solve this problem would be greatly appreciated.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Thank you but I already have an active support ticket.
I'm suspicious it's the router. I've purchased a Protectli appliance which I will setup with PfSense. If that resolves the problem I will update the thread.
- Copy Link
- Report Inappropriate Content
Same problem here. After a update of the TL-SG3428, the total VLAN network stop working. The only solution is to rebuild the whole network from scratch. Even a factory default and a backup file failed. I have no idea where it went wrong.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1967
Replies: 12
Voters 0
No one has voted for it yet.