Hi all,

I have come across a very concerning glitch with the EAP245 V4 which I just purchased.

I have ER605 router and EAP245 access point. I configured both in standalone mode.

On the ER605 router I have created 3 vlans (“native” vlan 1, vlan2 and vlan3).

I also created 3 SSIDs on EAP245 (all 3 WPA2 protected with strong passwords) and configured them as follows:

- SSID 1: WPA2, no vlan (all traffic goes to native vlan 1)

- SSID 2: WPA2, vlan 2

- SSID 3: WPA2, Guest mode enabled, vlan3

Once these are set up, everything works as expected at first. However, if I go into the wireless settings on EAP245 and change any of my networks/SSIDs vlan settings from “enabled” to “disabled” and back, suddenly my vlan-associated SSIDs lose password protection.

While these networks still show up as WPA2 protected in the EAP245 settings, in reality they are broadcasted as unprotected. I was able to join them from another device successfully, without being asked for a password. Once I joined them, I had internet connection. 

I rebooted my router, reset the EAP245, reconfigured the networks on it again, and experienced the same glitch again as described above.

Even if I messed up smth my vlans configuration, I can't imagine why this would result in security being dropped. I find this glitch vey concerning and don't feel like using this access point anymore. 
 

Thanks,