TL-SF1008P in combination with TP-Link EAP110 not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-SF1008P in combination with TP-Link EAP110 not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-SF1008P in combination with TP-Link EAP110 not working
TL-SF1008P in combination with TP-Link EAP110 not working
2023-04-03 08:38:14 - last edited 2023-04-04 00:47:18

Hi there,

 

I´ve got a Problem:

I use a TL-SF1008P. Ports 5-8 are in use with non POE devices. A TP-Link EAP110 access point is connected to port 1, this requires POE. The AP does not work and the lamp for port 1 does not light up on my switch.

I have set:

Extend 1-4: on
Priority 1-2: on
No matter what I change, the AP is not getting served.


What am I doing wrong?

  0      
  0      
#1
Options
1 Reply
Re:TL-SF1008P in combination with TP-Link EAP110 not working
2023-04-04 07:22:26

Hi @O0R1M ,

 

The issue you are talking about is POE Compatible issue I think.

As mentioned in the Specifications, EAP110 is using 24V Passive PoE for power, but TL-SF1008P support Standard POE.

This is the point, they are not compatible.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 426

Replies: 1

Related Articles