Hi!

I'm setting up two CPE510s, one as AP and one as Client.  They are 100 feet apart.  MAXtream is enabled on the AP (I didn't see how it can be enabled on the Client).

When I run "speed test" from the Client building, sometimes I get great results (50 Mbps down, 50 Mbps up).  Sometimes I get very bad upload speeds (0.8 Mbps up).  The bandwidth changes randomly... over the course of 10 minutes it can be good then bad. 

4 of 4 LEDs on the AP are all on.  Only 3 of 4 LEDs on the Client AP are on.

Any suggestions for where to start debugging this?

Tom