Firmware Update not possible
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi All,
i want to Update to the newest Beta Firmware 1.0.4 nut the Upload interrupts constantly.
I tried it via local IP from the OC200 and via omada.tplinkcloud.com and with Chrome, Edge and Firefox and 3 different PC.
All ended up with the same Result.
by the Way... why has the Download no Checksum Information?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
This is an issue I have, cannot upgrade using local, ddns or cloud login. Edit: solution for upgrade, read directions pt 4.
current versions
oc200 v1 5.9.32 1.24.0 Build 20230328 Rel.52384
er8411v1 1.0.3
Some behavior I noticed with the er8411
I have to reboot for some vpn ( ipsec tunnels ) subnets to reconnect, they randomly lose connection, dpd doesn't seem to work properly. Settings for VPN mirror what I used successfully for the last 2 yrs using a ER7206 to a UI-ER12P. Its failed to connect with an er7206 or a UI-ER12P on said VPN tunnels. Lowering the tunnel lifetimes have improved reliability, or at minimum make the tunnel outage shorter if its not noticed. Once the tunnel lifetime runs out it seems to reconnect.
- Copy Link
- Report Inappropriate Content
I have a software controller and upgraded without problems, but it looks like this is not supported on the hardware controller yet.
point 4 in the note to the beta version says this
(4) The above firmware doesn't support to be upgraded on Hardware Controller 5.9 and below, and it will be supported on Hardware Controller 5.11.
- Copy Link
- Report Inappropriate Content
This is an issue I have, cannot upgrade using local, ddns or cloud login. Edit: solution for upgrade, read directions pt 4.
current versions
oc200 v1 5.9.32 1.24.0 Build 20230328 Rel.52384
er8411v1 1.0.3
Some behavior I noticed with the er8411
I have to reboot for some vpn ( ipsec tunnels ) subnets to reconnect, they randomly lose connection, dpd doesn't seem to work properly. Settings for VPN mirror what I used successfully for the last 2 yrs using a ER7206 to a UI-ER12P. Its failed to connect with an er7206 or a UI-ER12P on said VPN tunnels. Lowering the tunnel lifetimes have improved reliability, or at minimum make the tunnel outage shorter if its not noticed. Once the tunnel lifetime runs out it seems to reconnect.
- Copy Link
- Report Inappropriate Content
You can forget it on the OC, and then upgrade it in standalone mode, then use the controller to adopt it, it will work.
- Copy Link
- Report Inappropriate Content
I have a software controller and upgraded without problems, but it looks like this is not supported on the hardware controller yet.
point 4 in the note to the beta version says this
(4) The above firmware doesn't support to be upgraded on Hardware Controller 5.9 and below, and it will be supported on Hardware Controller 5.11.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 590
Replies: 3
Voters 0
No one has voted for it yet.