Configuring Multi-Gig SPF with TL-SX3016F v1.0?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I'm on the latest firmware for this unit and I'm using QINIYEK 1.25/2.5/5/10G SFP+ to RJ45 Transceivers in this unit.
The link speed is negotiated correctly - i.e. 1Gbps or 2.5Gbps, but in the UI, it only shows 10G.
If I used profile overrides there are two issues:
- Does not have multi-gig profiles
- Forcing the link speed to say 1Gbps causes the SFP+ module to disconnect
Leaving the SFP+ at 10G does negotiate properly to the lower speed but the UI does not reflect this and any manual adjustment causes issues with the SFP module.
Is this expected, will it be fixed?
Thanks.
Hi @coolspot18
Thanks for posting in our business forum.
The device does not support 2.5 and 5Gbps. In this case, your connection drops after setting it to be 1Gbps, have you made a change to your other device to be 1Gbps from 2.5G?
There are no multi-gig profiles.
There is no fix to this as the speed is 1Gbps and 10Gbps.
Hi @coolspot18
Thanks for posting in our business forum.
The device does not support 2.5 and 5Gbps. In this case, your connection drops after setting it to be 1Gbps, have you made a change to your other device to be 1Gbps from 2.5G?
There are no multi-gig profiles.
There is no fix to this as the speed is 1Gbps and 10Gbps.